Abstract:To address the falling weld-spatter hazards and safety deficiencies of conventional mobile protective shed schemes during the erection of 50 m long-span open-channel steel beams spanning an operating expressway, an integrated assembled protection bracket construction technique is proposed. In this method, the sealed steel plates are added at the bottom of the open-channel beam to intercept the weld slags. The high-strength lifting lugs are welded to both webs of beam and the detachable triangular brackets are mounted, integrating the protection system with the beam for simultaneous hoisting by a 320 t beam-erection machine. Through the combined load calculations, it is verified that the strength, stability and stiffness of the lifting lugs, diagonal struts and bottom plate with the integrated process meet the code requirements. And the independent hoisting operations can be reduced by approximately 75%, the construction period shortened by about 60%, the high-altitude working hours reduced by roughly 62.5%, the protective components reused 3 to 4 times, and the protection cost of a single beam reduced by approximately 35% compared to the traditional schemes. The results prove that the integrated process can effectively solve the problems of slag fall and high-altitude protection in the overpass construction of long-span steel beams. The safety and economic benefits are significant, which can provide technical references for similar overpass bridge projects.