Abstract:To address the increase in moisture content of highway subgrades in high-rainfall regions caused by rainfall infiltration and capillary water migration, a field test section of the Ruili–Nongdao Expressway in Yunnan Province was selected. A superhydrophobic polymer was used to construct a water-barrier layer in the subgrade, and continuous in-situ moisture-content monitoring was conducted using frequency domain reflectometry (FDR). The test section was 100 m long, consisting of a 50 m superhydrophobic treatment section and a 50 m conventional subgrade control section, with five groups of FDR sensors installed. The results showed that moisture fluctuations were most pronounced in the shallow layer at depths of 30–60 cm, where the volumetric water content mainly ranged from 12% to 18%; the fluctuations decreased markedly near a depth of 80 cm; and the deeper layer at depths of 100–140 cm maintained relatively high moisture contents, generally ranging from 24% to 34%. Compared with the control section, the superhydrophobic treatment section exhibited significantly lower peak moisture contents and smaller fluctuation amplitudes in the shallow layer, together with a certain lag in moisture response. Moreover, the high moisture content in the deeper layer did not continuously propagate into the 0–80 cm zone enclosed by the water-barrier layer. These results indicate that the superhydrophobic water-barrier layer can effectively suppress moisture migration within the subgrade and improve the stability of the internal moisture field.